The optional CheckSum fixture kits, KIT2KN-QC or KIT1000-QC, are low-cost to minimize your recurring costs. The kits include storage handles to make storage and moving easy. Installing the fixture kit simply involves clicking the two parts into place. The bottom assembly includes a fiberglass probe plate with a fixture interface section and pan covering the wiring.
The top assembly is a clear polycarbonate plate that is used with pressure rods to press the UUT down onto the guide pins. It can be machined and milled with openings for top access to the UUT to allow for switch settings and adjustments. The front and sides of the UUT are accessible during test time for access to adjustments.
To run a test, the operator places the UUT on the fixture's guide pins, then presses the start buttons. Once the test is completed, the system displays the results and the fixture top automatically rises so the UUT can be removed.
The configuration of the Analyst ems+ft as a complete, ready to use, 400 test point test system:
- TR-10-EMSFT System Electronics with Analyst ems+ft Test Executive Software
- FUNC-2 Functional Test module
- X-Point-1 Relay Bus Interconnect Switch module
- Eight (8) MPX-2-50 50-Point ICT/Functional MPX modules
- PWR-2 Power module
- Two (2) DIG-1 48-Pin Digital I/O modules
- SMT-2 TestJet License with 24-Channel SMT / Capacitance Polarity module
- GPIB-USB USB to IEEE-488 Controller
- ICU20 Industrial 20-slot Chassis with USB system module
- TPCX Tower PC, Windows XP with USB 2.0 control
- T-120-2P Printer
- TR-9-2000-QC Long-Travel Pneumatic Fixture System
- PS-UUT-2 Two Programmable Power Supplies
- CM-3-KIT2KN Calibration/Verification Fixture
|
